RADIUM ENGINEERING

 Replacement orifice for many Radium Engineering products including MPR, DMR, FPR-D, FST-R, etc.

 Replacement orifice for many Radium Engineering products including MPR, DMR, FPR-D, FST-R, etc.

Black zinc-plated 10-32 thread to 3AN adapter machined from high strength steel. Allows connection of a 3AN hose to the vacuum port on the parts listed below. Compatible with the following Radium products ONLY:

Description  These adapter fittings are designed to be used in many Radium products including fuel rails, surge tanks, fuel pressure regulators, etc. However, they can be used in any application using a -8AN ORB (3/4"-16)...

Description  These adapter fittings are designed to be used in many Radium products including fuel rails, surge tanks, fuel pressure regulators, etc. However, they can be used in any application using a -8AN ORB (3/4"-16)...

V2 Quick Connect fittings are found on many OEM vehicles including BMW, VW, Audi, Lamborghini, Ford, etc. These Radium Engineering fittings adapt many crankcase ventilation connectors to 10AN male. They are primarily used for air/oil...

The 14-0359 is commonly used with the popular Bosch PST-F1 absolute fluid pressure/temperature sensor. It is also compatible with the 2018+ Mustang GT fuel rail sensor and is required to install Radium 20-0433 Fuel Rail...

Radium P/N: 14-0358 is required to adapt the OEM direct injection pump feed hose on the direct-injection Ford Coyote 5.0L V8. Notes: 1 x Fitting included only. Photo shown with rail kit and OEM manifold...

Description  These adapter fittings are designed to be used in all Radium catch cans. However, they can be used in any application using a -10AN ORB (O-Ring Boss) port.  All fittings include O-rings, excluding the...

Description  These anodized billet aluminum adapter fittings can be used in any application using a 7/16"-20 O-ring port. This is the same thread pitch used in -4AN (ORB=O-Ring Boss). They all feature FKM (Viton) O-rings...

NPT (National Pipe Thread) fittings seal by the intentional interference created by the tapered threads meshing together. Always use a small amount of PTFE paste or tape on NPT threads and tighten to finger tight,...

These anodized billet aluminum adapter fittings can be used in any application using a 9/16"-18 O-ring port. This is the same thread pitch used in -6AN (ORB=O-Ring Boss). They all feature FKM (Viton) O-rings for...