Radium AN ORB to Male AN Flare Fitting
These threaded adapter fittings are compatible with AN ORB (O-ring boss) ports. Because the threads on these fittings are not used for sealing, PTFE paste or thread sealant is not required. The O-ring should be...
Radium AN ORB to Hose Barb Fittings
These threaded adapter fittings are compatible with AN ORB (O-ring boss) ports. Because the threads on these fittings are not used for sealing, PTFE paste or thread sealant is not required. The O-ring should be...
Radium AN Male to NPT Male Straight Fittings
NPT (National Pipe Thread) fittings seal by the intentional interference created by the tapered threads meshing together. Always use a small amount of PTFE paste or tape on NPT threads and tighten to finger tight,...
Radium AN Male Flare to Metric Male Fittings
Radium Metric Fittings are a just a few of the optional fittings for both inlets and outlets of the catch cans, manifolds or any other project you have.
Radium AN Male Flare to Hose Barb Fitting
Radium Male AN flare to barb fittings in various sizes. These are not PushLok and will require clamping.
Radium Replacement Stainless Steel FPR Fuel Pressure Regulator Orifice
Stainless steel replacement orifice for many Radium Engineering products including MPR, DMR, FPR-D, FST-R, and a few fuel pump hangers. It has a smooth radius entry and is compatible with older regulators as well as...
Radium 1/4" Push-To-Connect Vacuum Port Adaptor
This is a vacuum fitting that adapts 10-32 thread to 1/4" push-to-connect. Machined from brass then nickel-plated with Buna-N O-rings. NOTE: The required hard plastic 1/4" OD tubing must be purchased elsewhere. These adapters are compatible...
Radium V2 Quick Connect, 15mm Female to 10AN Male Straight VW Mk8 GTI/R, Audi S3 8Y, BMW M3 E46
14-0763 V2 QUICK CONNECT, 15MM FEMALE 10AN MALE STRAIGHT This fitting adapts the male side of a 15mm V2 quick connect to 10AN male. Engine Compatibility -Audi S3 8Y (EA888) -BMW M3 E46 (S54) -VW...
Radium PushLok Hose End 10AN 60 Degree
Description Reuseable bright-dipped anodized aluminum Push-Lok hose ends. -6AN is for 3/8" hose -8AN is for 1/2" hose -10AN is for 5/8" hose -12AN is for 3/4" hose NOTE: All straight hose ends and 90...
Radium 8AN ORB to 10mm Hose Barb Fitting
These threaded adapter fittings are compatible with AN ORB (O-ring boss) ports. Because the threads on these fittings are not used for sealing, PTFE paste or thread sealant is not required. The O-ring should be...
